HV-System Solutions

The high voltage power supply of the type series CAPTEC, GLOWTEC, VAPTEC, LITEC and WELTEC could be work in parallel mode to increase the output power. For this purpose, the power supplies could connected in parallel mode by means of optical fibers cables and one of the power supplies have to configured as master and the others as slave. The total power, then divided evenly on a percentage on the devices connected in parallel. If desired, J. Schneider also takes over the installation of these devices in the necessary control cabinet included

  • all necessary pre-fuses
  • the necessary auxiliary voltages
  • the necessary interlock circuit
  • if necessary, necessary cooling water circuit
  • the desired sub-Distribution

The maximum possible total output per device series can be found in the following table.

Selection Table

Module
No. of max. parallel unitsVoltage Range
Power Range
CAPTEC

7

7

2

1kV-10kV
20kV-40kV
50kV-60kV

10kW-70kW
21kW-147kW
15kW-30kW

GLOWTEC DC

7

7

2

2kV-10kV
20kV-40kV
50kV-60kV
10kW-70kW
21kW-147kW
15kW-30kW
GLOWTEC DCp72kV-5kV10kW-70kW
GLOWTEC AC

2

7

2kV-5kV10kW-70kW
VAPTEC

7

7

8kV-10kV
20kV or 5kV
10kW-70kW
21kW-147kW
LITEC102kV or 5kV12kW-120kW
WELTEC260kV-150kV15kW-30kW

 

 

 

 

 

 

 

 

 

 

 

 

 

The control cabinets are constructed according to the DIN VDE 0100 regulations the protective conductor system is tested according to DIN VDE 0100, part 600; Insulation and functional testing largely carried out in accordance with DIN VDE 0113 / 06.93 EN 60204.