Options & Software


Multi I/O

The Multi I/O interface extension enables the integration of the UPS in several controlsystems, because incoming and outgoing lines can be completely configured. 

for further information click here

Multicom 384

The MultiCom 384 delivers relays contacts for the management of the alarm states of the UPS. The board possesses two extendible terminal strips. On one of them the ESD signal (emergency stop of the UPS) and the RSD signal (remote switchoff) are included. The board also allows to connect the display of battery operation, bypass, alarm and "battery nearly discharged" with potentialfree, switched-over or closer contacts.

Operational Instruction200123pdf




NetMan 204

The NetMan 204 network agent allows management of UPSs connected directly to a LAN using the communication protocols (TCP/IP, HTTP, and SNMP).

It was developed to integrate UPSs into medium and large networks and to ensure high reliability and security in the communication between the UPSs and the associated monitoring Systems. 

  • Processor RISC, 32bit
  • Compatible with 10/100Mbps Ethernet and IPv4/6 Network
  • Compatible with PowerShield3 and TeleNetGuard
  • SNMP v1, v2 and v3 with RFC1628 for PowerNETGuard and NMS Connection
  • SNMP v1, v2 and v3 with RFC3433 for environmental sensor Control
  • SSH for secure connection and configuration
  • HTTP for controlling the UPS via Web Browser
  • SMTP for sending e-mail about operating and alarm states of the UPS
  • BACnet/IP
  • Maximum expandability
  • USB Host for the connection of Pendrive USB
  • Management of historical events and data
  • Administration Wake On Lan to switch on the PC via TCP/IP Network
  • Other standards: DHCP, DNS, RARP, FTP, NTP, ICMP, IGMP
  • Configurable via SSH or HTTP Connection
  • Firmware update via FTP and HTTP 
Operational Instruction200123pdf





UPS Mon5

The control and shutdown software for all Windows versions from 95b, Linux, Novell and iMac, available in Freeware and fullversion.

Please contact us!


Intelligent Redundant Multi Switch (IRMS) 

Today only high power server have a redundant UPS power supply and so possess double protection. This ensures increased safety and availability of the high power server.

But what about most of your equipment such as hubs, switches, routers and server for which a redundant power supply doesn't pay off?

For these cases we developped the Intelligent Redundant Multi Switch. The IRMS enables a redundant power supply of all critical loads.

The feed-in can be realized by two independant mains, by one mains and one UPS system or by two UPS systems. If one supply fails, the IRMS switches automatically and without interruption on the available supply. Because the switch-over is realized without interruption, the load are not influenced.    

So the proper function of the controlsystem is guaranteed even in case of interrupted or strong disturbed supply.

The IRMS systeme administrates the automatic switch-over to the secondary power supply for loads which are connected to the failed feeding line. The duration of the mains failure, which causes the switch-over can be adjusted by software.

To minimize reaction times, the switch-over in case of mains failure is noch affected in zero-point but at once.

inputs:         2 x 230 V with 16 A each
outputs:       8 x 230 V with 4 A each